Installation Guide and Disclaimer for Wire Wheels and Knock-Offs

Wire Wheel:

For show use only—not intended for daily driving or regular road use and cannot be balanced for high-speed driving (above 45 mph). All wire wheels may extend beyond the fenders, and the customer fully understands and agrees to this condition. Upon purchase, the buyer assumes all liability and responsibility for proper installation and maintenance, including tightening knock-offs every 40 miles and checking tightness every few weeks. Comes with a limited 1-year structural warranty and a 90-day finish warranty. Silicone seals are not covered under warranty. 

Limited Warranty

• Wheel Structure: 1 year
• Wheel Finish: 90 days

※Please Read Before Mounting Tires※

1. No Returns After Tire Mounting:
   •    ㆍWheels cannot be returned due to fitment issues once tires have been mounted.
2. Caution with Tire Changers:
   •    ㆍPower-assisted tire changers can damage wheels. Please use them with care.
3. Tube-Type Wire Wheels:
   •    ㆍTubes must be used with tube-type wire wheels.
4. Stud Length Requirement:
   •    ㆍEnsure that the stud length does not exceed 1 1/8 inches. Excessively long studs may prevent proper tightening of the wheels.
5. Radial Tire Direction:
   •    ㆍRadial tires must be remounted on the same side of the vehicle from which they were removed.
   •    ㆍDo not change the direction of rotation.
6. Air Pressure Limit - To ensure safety and proper use of tires, it is essential not to exceed the recommended inflation pressures:
      ㆍ13" to 15" tires: Do not inflate beyond 35 psi.
      ㆍ16" and larger tires: Do not inflate beyond 40 psi.

Check Stud Length:

•    ㆍIf the stud length exceeds 1 1/8 inches, cut the stud to shorten it or use a spacer behind
•    ㆍthe adapter to adjust the length.

Ensure Correct Positioning of Hub Adapters:

•    ㆍVerify that the hub adapter fits flat against the hub and the brake mounting pad.
•    ㆍIf there is any interference, identify the point of contact and remove any high points.

Proper Adapter Installation:

•    ㆍOn the left side of the vehicle, install the hub adapter marked "LEFT" with the white mesh thread protector.
•    ㆍOn the right side of the vehicle, install the hub adapter marked "RIGHT" with the red or brown mesh thread protector.

Important Installation Instructions

1. Avoid Using High-Impact Wrenches: Do not use high-impact wrenches to secure lug nuts. This can damage the adapter and result in improper lug nuts torque.
2. Check Adapter Rotation: Once installed, the adapter should rotate freely by hand without rubbing or interference.

Wheel Rotation Test:

•    ㆍSpin the wheels by hand to ensure there is no rubbing against the brake calipers.
•    ㆍRock the wheel assembly to confirm that the knock-off cap is fully seated on the wheel.
•    ㆍEnsure there is no looseness.

Cap Retightening:

•    ㆍAfter lowering the vehicle, use a lead hammer to firmly tighten the caps by hammering them.
•    ㆍThere should be no movement, even under the hardest blows from the hammer.

•    ㆍAfter the initial 25 miles of driving, re-check the tightness of the knock-off caps. Continue to tighten them every 40 miles, then check their tightness every few weeks thereafter
•    ㆍWire wheels should always be checked regularly to ensure the knock-off caps are properly tightened.